Setting The Vehicle Gap; Setting A Speed; Changing The Set Speed - Ford KUGA Owner's Manual

Using the System
Use the steering wheel controls to operate
the system.
F
D
E133195
A Set speed increase
B Set speed decrease
C On and off
D Gap increase
E Gap decrease
F Cancel and resume
Switching the System On
Press switch C. The system is set to
standby mode.

Setting a Speed

Note: The system must be in standby
mode.
Press switch A or B to select your desired
cruise speed. The speed is displayed in the
information display and stored as the set
speed.

Changing the Set Speed

Note: Vehicle speed may be increased and
decreased at intervals of 5 mph or 5 km/h
depending on your unit of measure setting.
Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3585en enGBR, Edition date: 08/2014, First Printing
Cruise Control
Note: If the system does not react to these
changes the reason may be that the gap
interval to the vehicle in front of you
prevents an increase in speed.
Press switch A to increase or switch B to
decrease the set speed until the desired
A
set speed is shown in the information
display. Your vehicle speed will gradually
change to the selected speed.

Setting the Vehicle Gap

Note: Use the appropriate gap setting in
accordance with local traffic regulations.
Note: The gap setting is time dependent
and therefore the distance will
automatically adjust with your speed. For
B
example on a gap setting of four bars, the
time gap is 1.8 seconds. This will mean that
at a speed of 62 mph (100 km/h), the
distance to the vehicle in front of you will
be maintained at 164 feet (50 meters).
Note: If you depress the accelerator for a
short period of time, for example when
overtaking, the system will temporarily
switch off. It will switch back on when you
release the accelerator pedal. A message
will be shown in the display.
Note: The gap setting will remain
unchanged each time you switch the ignition
on.
E82311
148