Stowing The Wheel And Vehicle Jack - Ford Transit Owner's Manual

WARNINGS
Make sure the wheel and hub
contact surfaces are free from
foreign material.
1. Install the wheel.
2. Install all of the lug nuts and partially
tighten them in the sequence shown.
3. Lower your vehicle and remove the
vehicle jack.
4. Fully tighten all of the lug nuts in the
sequence shown. See Technical
Specifications (page 190).
5. Install the wheel trim.
Note: Make sure that the cones on the lug
nuts are against the wheel.
Note: Alloy wheel lug nuts are suitable for
use on a steel spare wheel.
Transit (TTG) Vehicles Built From: 06-01-2014, Vehicles Built Up To: 31-12-2014, CG3612en enGBR, Edition date: 12/2013
Wheels and Tires
Note: If the spare wheel is not the same
type and size as your vehicle road wheel
replace it as soon as possible.
Note: Check the lug nuts for correct
tightness and check the tire pressure as
soon as possible. See Technical
Specifications (page 190).
Stowing the Wheel and Vehicle
Jack
Note: Do not raise the spare wheel bracket
without a wheel attached. Damage can
occur to the winch mechanism if the spare
wheel bracket is lowered without a wheel
attached.
1.
2. Slide the cable through the slot and
3. Rotate the cable through 90 degrees
4. Insert the flat end of the wheel brace
189
Attach the spare wheel bracket to the
wheel using the retaining nut.
attach the spare wheel bracket to the
winch.
and lower the cable end cover.
or the short arm of the jack handle into
the socket. Turn it clockwise until you
feel a strong resistance. Make sure the
wheel is secure.