Ford Transit Owner's Manual page 187

3. Rotate the cable through 90 degrees.
Slide the cable through the slot to
release the spare wheel bracket from
the winch.
4. Remove the retaining nut to release
the spare wheel bracket.
Vehicle Jack
WARNINGS
Only use the vehicle jack supplied
with your vehicle when changing a
wheel in an emergency.
The vehicle jack must not be
damaged or deformed and the
thread lubricated and free from
foreign material.
Never place anything between the
vehicle jack and the ground.
Never place anything between the
vehicle jack and your vehicle.
Make sure that the vehicle jack is
vertical to the jacking point and the
base is flat on the ground.
Do not work on your vehicle when
the jack is the only support. If the
vehicle slips off the jack, you or
someone else could be seriously injured.
Transit (TTG) Vehicles Built From: 06-01-2014, Vehicles Built Up To: 31-12-2014, CG3612en enGBR, Edition date: 12/2013
Wheels and Tires
Note: Vehicles with a Temporary Mobility
Kit do not have a vehicle jack or a wheel
brace. See Temporary Mobility Kit (page
176).
Front Wheel Drive Vehicles and Rear
Wheel Drive Vehicles up to T370
The vehicle jack and wheel brace are
located in a storage compartment in the
front right-hand side stepwell.
1.
2. Insert the hook of the jack handle into
185
Unfold the jack handle.
the ring on the vehicle jack. Insert the
wheel brace into the end of the jack
handle and rotate clockwise to raise
your vehicle. Rotate counterclockwise
to lower your vehicle.