Chapter 5: Setting The Alarm (Code/Tag) - Pyronix Wireless Alarm system User Manual

C H A P T E R 5 : S E T T I N G T H E A L A R M ( C O D E / T A G )
Ø Enter your user code
Or
Ø Present a valid tag
Ø Enter the level set you wish to set, and
press the
YES
Ø 'Please wait arming wireless' will be
displayed
Ø There are three different setting
methods your installer will instruct you
through which of these has been
designed into your system.
Ø Final Door: Leave the building and
make sure the exit door is closed
properly
Ø Timed: Make sure you leave the
building before the timer shown on the
keypad expires
Ø Push to set: Press the push to set
button installed by your engineer to
arm the system
SETTING USING A WIRELESS KEY-FOB
Ø To set via a key-fob. Press the
Ø The key-fob LED will start to flash
GREEN indicating that the system is
starting to set
Ø 'Please wait arming wireless' will be
displayed on the keypad and the
programmed area will begin to set.
Ø To 'quick set', press the
Ø Once set, the key-fob LED will
illuminate RED indicating that the
system is now set
key
key
key again.
Page: 8