Controller Options; Latch Adjustment - Cumberland Stove Works MF3800 Operator's Manual

MOUNTING THE CONTROLLER
The CSW MF Series Stove has three different controller
mounting options:
1. Back of the stove with controller visible.You may mount
the conrollter on either side of the rear of the stove (see
figure 8) so it is visible during operation. To do so use the
metal mounting bracket and the (4) self-tapping screws ((2)
through the plastic bracket and (2) through the back panel
of the stove). Attach through the pre-drilled holes.
note: Self-tapping screws must penetrate hopper.
2. Back of the stove with controller hidden. You may mount
the controller on either side of the stove (see figure 9). So it
is not visible during operation. Attach the plastic mounting
bracket to the pre-drilled holes on either side of the stove
using the (2) self-tapping screws.
note: Self-tapping screws must penetrate hopper.
3. Wall mounted (figure 10). You may mount the controller
on the wall next to the unit using two drywall screws. It is
best to embed the screws into a stud. Use a stud finder to
locate studs in the wall.
PLUG STOVE INTO CONTROLLER
After mounting the controller plug the phone cord from the
back of the stove to the underside of the controller.
MOUNT DOOR
Take off protective cardboard. Hang door on hinges
making sure it's seated properly so latch is aligned with
latch cut-out.

LATCH ADJUSTMENT

The door gasket may settle after use and adjustment to
latch is necessary to ensure proper seal. To adjust latch
remove roll pin and swap washers from the inside of door
to the outside of the door. Replace roll pin and inspect
door fit.
Page 0
Figure 8: Controller on metal bracket in back.
Figure 9: Controller on plastic bracket in back.
Figure 10: Controller on wall.
CumberlandStoveWorks.com
INSTALLATION AND OPERATION MANUAL
MF3700, MF3800 Models
Figure 11: Door Latch Adjustment.
800-345-6007