Operating Stove - Cumberland Stove Works MF3800 Operator's Manual

OPERATING STOVE

Once the stove has been properly installed and plugged
into a grounded surge protector you are ready to begin
operation.
IMPORTANT: Before filling the hopper make sure all
shipping and packaging items are removed from the
hopper and there are no obstructions in the auger housing
opening.
Fill the hopper with an approved solid fuel and close the
lid.
The first screen you will see upon power up is the model
and version of software loaded in the control. It will then
default to the Fuel Range Selection Mode.
FUEL RANGE SELECTION
The CSW Multi Fuel Parlor stove has four fuel ranges
and six heat output Levels within each fuel range. This
gives the stove 24 levels of variability maximizing burn
with your chosen fuel. Range 1 Level 1 is the lowest feed
rate/combustion airflow and Range 4 Level 6 is the highest
feed rate/combustion airflow. See figure 23.
rangeS For aPProveD FueLS
• Corn 1-2
• Wood Pellets 2-3-4
• Cherry Pits 4
SeLeCting the range
The control will offer two selections on the screen. To
browse through the range selections use the SCROLL
button. To choose a range scroll through until the desired
Range is on top and press ENTER. Range may be changed
at anytime during stove operation by pressing the SCROLL
Range 4
Range 3
Range 2 Levels 1-6
Range 1 Levels 1-6
Lowest Feed Rate/
Combustion Airflow
Figure 23: Feed rate chart.
Page 6
Levels 1-6
Levels 1-6
Highest Feed Rate/
Combustion Airflow
CumberlandStoveWorks.com
INSTALLATION AND OPERATION MANUAL
WARNING
NEVER PUT STARTING PELLETS OR BURN GEL INTO
THE HOPPER OF THE STOVE. THIS COULD RESULT
IN DEATH OR SERIOUS INJURY AND OR PROPERTY
DAMAGE. DOING SO WILL VOID ALL WARRANTIES.
button.
Starting a Fire
After the Range has been loaded the controller will then
instruct you to light the fire. MF3700 stove controllers will
read as follows:
LIgHT FIRE
PUSH ON BUTTON
Stoves equipped with electric ignition (model MF3800) will
have the option of starting the fire manually or automatically
with the igniter. The screen will read as follows:
ELECTRIC IgNITE
yes
no
Pushing SCROLL will send the controller to the LIGHT
FIRE PUSH ON BUTTON. See Manual Lighting Instructions
before starting fire or pushing ON. For electric ignition read
ELECRTRIC IgNITION INSTRUCTIONS before pressing
ENTER.
manuaL Lighting inStruCtionS
IMPORTANT: Before lighting the stove for the first time,
make sure that no shipping items have been left inside the
firebox or ash pan.
When initially filling an empty hopper you must prime the
feed auger. To prime the auger press the ADD FUEL button.
This will turn on your auger on for one minute or until the
ADD FUEL button is pressed again. Run feed auger until
you see fuel start to drop into the firepot.
Note: The parlor stove has been designed with a safety
switch on the hopper lid. The auger will not run with the
hopper door open.
Fill the firepot with about one cup of starting pellets or
wood pellets. If wood pellets are used, squirt about two
tablespoons of burn gel on pellets.
Light the material in firepot using a match or a grill type
MF3700, MF3800 Models
800-345-6007