Unpacking & Assembly - Cumberland Stove Works MF3800 Operator's Manual

UNPACkING AND ASSEMBLY
Unpack all hardware located in the units hopper and ash
pan. The following should be included:
4 - legs (710008) w/ levelers (725010)
4 - tie-down straps (700136)
1 - firepot cleaning rod (700076)
1 - cleaning rod spring (720053)
1 - hopper lid handle (730006)
1 - power cord (720045)
1 - scraper tool (700225)
1 - door (700311) with glass (720002)
and handle (700351, 700359)
1 - controller (730053)
1 - steel mounting bracket (700349)
1 - pre-made parts bag (small) which includes:
4 - 1/4-20 x 2" tie-down bolts (725015)
2 - 8-32 x 3/8" hopper lid handle bolts (725012)
12 - 5/16-18 x 3/4" leg bolts (1501)
4 - #8-18 controller bracket screws (725027)
MOUNT LEGS
note: Stove is heavy. team lifting is recommended.
1. gently tilt the stove on its side.
2. Assemble the legs using provided (12) leg bolts as
shown in figure 4.
note for mobiLe home inStaLLation: if unit is
to be used in a mobile home, you must install the
(4) tie-down straps to the stove now. refer to page
15 for instructions.
3. After all bolts have been tightened, set the stove back
up on its legs.
MOUNT HANDLE TO HOPPER DOOR
1. Using a Phillips screwdriver, attach hopper handle to
hopper door using the pre-drilled holes. See figure 5.
ASSEMBLE FIREPOT CLEANING ROD
1. Thread spring over non-threaded end of rod.
2. Place threaded end of firepot cleaning rod through
decorative casting and screw into fire pot. See figure
6.
NOTE: It is important for the fire pot to slide freely in
and out of the pot holder. Fire pot must seal tight
when pushed in.
PLUG IN POWER CORD
1. Plug power cord into the back of stove. See figure 7.
800-345-6007
Figure 4: Leg Assembly
Figure 5: Hopper Door Handle Assembly
Figure 6: Ash Shuttle Rod Assembly
Power Cord Receptacle
Figure 7: Ash Shuttle Rod Assembly
CumberlandStoveWorks.com
INSTALLATION AND OPERATION MANUAL
MF3700, MF3800 Models
Page 9