Unpacking & Assembly - Cumberland Stove Works MF3800 Installation And Service Manual

Multi-fuel parlor stove
Hide thumbs Also See for MF3800:
Table of Contents

Advertisement

UNPACKING AND ASSEMBLY
Unpack all hardware located in the unit's hopper and ash pan.
The following should be included:
4 - legs (710008) w/ levelers (725010)
4 - tie-down straps (700136)
1 - firepot cleaning rod (700076)
1 - cleaning rod spring (720053)
1 - hopper lid handle (730006)
1 - power cord (720045)
1 - door (700311) with glass (720002)
and handle (700351, 700359)
1 - controller (730053)
1 - steel mounting bracket (700349)
1 - pre-made parts bag (small) which includes:
4 - 1/4-20 x 2" tie-down bolts (725015)
2 - 8-32 x 3/8" hopper lid handle bolts (725012)
12 - 5/16-18 x 3/4" leg bolts (1501)
4 - #8-18 controller bracket screws (725027)
MOUNT LEGS
NOTE: Stove can be installed with or without legs. If legless
installation is preferred, you may skip this step.
NOTE: Stove is heavy. Team lifting is recommended.
1. Gently tilt the stove on its side.
2. Assemble the legs using provided (12) leg bolts AS SHOWN
IN FIGURE 1.
NOTE for MOBILE HOME INSTALLATION: If unit is to be
used in a mobile home, you must install the (4) tie-down
straps to the stove now. Refer to page 17 for instructions.
3. After all bolts have been tightened, set the stove back up
on its legs.
MOUNT HANDLE TO HOPPER DOOR
1. Using a Phillips screwdriver, attach hopper handle
t o h o p p e r d o o r u s i n g t h e p r e - d r i l l e d h o l e s .
SEE FIGURE 2.
ASSEMBLE FIREPOT CLEANING ROD
1. Thread spring over non-threaded end of rod.
2. P l a c e t h r e a d e d e n d o f f i r e p o t c l e a n i n g r o d
through decorative casting and screw into firepot.
SEE FIGURE 3.
NOTE: Firepot must seal tight when pushed in.
• The upper baffle (700202), FIGURE 4, is located in the
top of the firebox.
PLUG IN POWER CORD
1. P l u g p o w e r c o r d i n t o t h e b a c k o f s t o v e .
SEE FIGURE 5.
FOR QUALIFIED INSTALLERS ONLY
CumberlandStoveWorks.com
INSTALLATION AND SERVICE MANUAL
Figure 1: Leg Assembly
Figure 3: Ash Shuttle Rod Assembly
Figure 4: Upper baffle in
top of firebox
Power Cord
Receptacle
Figure 5: Power Cord Receptacle
Model MF3800
Figure 2: Hopper Door Handle
Assembly
Upper baffle
Page 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents