Closing The Power Pump Module And Reinstalling The Control Unit; Reinstalling The Front Panel - Viessmann VITODENS 100-W WB1B Series Installation And Service Instructions Manual

Electrical Connections

Closing the power pump module and reinstalling the control unit

Fig. 40

Reinstalling the front panel

Fig. 41
(continued)
Control Connections
1. Reinstall power pump module
cover plate.
2. Install control cover (if previously
removed).
3. Flip control upward and lock into
position.
CAUTION
Electrical cables may become
damaged if in contact with hot
components.
When running and securing
connecting cables on site, ensure
that the maximum permissible
temperatures of the cables are not
exceeded.
1. Set front panel on the guide rails
and push in place.
2. Tighten screws at the bottom.
IMPORTANT
Read and follow, where applicable,
the safety instructions of all labels
and stickers attached to boiler
surfaces. Do not remove any of these
instructions. Contact Viessmann if
any replacement labels are required.
39