Motorola CLP1013 User Manual page 34

What to do if cloning fails
The radio will emit an audible "bonk" indicating
that the cloning process has failed. In the event
that cloning fails, try performing each of the
following before trying to start the cloning
process again.
1. Make sure that the radio batteries on both
radios are fully charged.
2. Verify the cloning cable connection on both
Single Unit Chargers.
3. Make sure that the battery is engaged
properly on to the radio.
4. Make sure that there is no debris in the
charging tray or on the radio contacts.
5. Verify that the source radio is in cloning
mode.
6. Make sure that the radio to be cloned is
turned ON.
26
English
7. Make sure that radios are both from the
same type (same frequency band, same
region and same transmission power).
Note: This cloning cable is designed to operate only with
compatible Motorola Drop-in Tray Single Unit
Charger. When ordering the cloning cable, please
refer to CLP Series Cloning Cable Kit P/N
HKKN4026. For details about accessories, refer to
"Accessories" Section on page 42.