Eclipse AVN4400 Owner's Manual page 20

AudioNldeo operation
~:, '
~.:
..
"
,,-------_._-------------------------------------._------------------------------------_._---------------------------------~\
To adjust the non-fader level (NON-FADER LEVEL)
I You can adjust the non-fader level (for connected sub-woofer).
o
Turn the VOL rotary knob to adjust the non-fader level.
To choose the phase (NON-FADER PHASE)
I
The merger of sound between the front and rear speakers and the woofer
can be improved by selecting the phase. Switch the phase which lets the
speakers combine without any disharmony.
10
Turn the VOL rotary knob to choose the phase.
• Right:
NORMAL
Make the output timing of the front/rear speakers and the woofer the same.
Left:
REVERSE
Change the phase of the output timing of the woofer.
VOL rotary knob to adjust the frequency filtering
I
!
!
!
!
I
!
I
i
I
~ Turn the
settings.
• Right:
LPFON
Only allow lower frequencies (low range) through.
Left:
LPF OFF
Allow all frequencies through regardless if the frequencies are low or high_
I
You can adjust the frequency filtering settings.
I
!
II
Accentuate low and high frequencies when the volume is low.
When loudness is ON, the apparent deficiency in the high sounds is
compensated for.
l
Turn the VOL rotary knob to set the loudness ON/OFF.