Common Screen Commands; Demod Select; Save Parameters To Permanent Storage; Exit - Comtech EF Data Vipersat CDD-562L User Manual

G en e r a l MN/22137, rev 1

Common Screen Commands

The following commands appear on each of the menu screens:

Demod Select

Some feature configurations apply to the CDD-56X as a unit, others are set on a
per Demod basis. This command (enter Z) allows the selection of one of the
two (CDD-562L) or four (CDD-564/564L) Demodulators.

Save Parameters to Permanent Storage

To Save the current parameter settings to permanent storage, enter S at the
command prompt. This command saves all data that has been entered from any
of the CLI screens since the last save was executed. Exiting a screen without
saving after parameters have been changed does not mean that the changes are
not applied. However, if these changes are not saved prior to a system reset or
power cycle, they will be lost.

Exit

To Exit the current menu screen and return to the previous screen in the menu
tree, enter X at the command prompt.

Telnet Logout

Enter L at the command prompt to Logout of the Telnet session. This command
appears only when connected via Telnet.
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e
3-2