Avaya P460 Installation And Maintenance Manual page 43

Note: Press both buttons simultaneously for 1.5 seconds to reset the SPV supervisor
module.
Press both switches simultaneously for five seconds to reset the entire switch. Refer
to "M460ML-SPV Left and Right Pushbuttons" on page 31 for full details of reset
options.
Table 5.6 summarizes the meanings of the function LEDs. Certain indications
depend on the specific I/O module port type:
Table 5.6
LED
LNK
COL
Tx
Rx
FDX
FC
HSpd
Avaya P460 Installation and Maintenance Guide
M460ML-SPV Function LEDs
Description
Port status
Collision detection
Transmit to line
Receive from line
Full-/Half-duplex
Indication
Flow Control
Port speed indication
Chapter 5
State Meaning
ON Port enabled and link OK
OFF Port disabled or link is not
operating
ON Collision occurred on line
OFF No collision or FDX port
ON Data transmitted to the line
OFF No transmit activity
ON Data received from the line
OFF No receive activity
ON Full-duplex mode
For 10/100BASE-T ports when
the link test fails with auto-
negotiation enabled
OFF Half-duplex mode
ON Flow Control is active
OFF Flow Control is disabled
ON Port 10/100
100 Mbps 1000 Mbps
OFF Port 10/100
10 Mbps N/A
Avaya P460 Panels
1000
1000
29