Installation
Install Lens Motor:
1. Position the AutoScope Lens Motor (item #2) as shown in Figure 3-7.
2. Line up the mounting holes on the lens motor housing with those on the underside of
the projector.
3. Secure the motor to the projector with the four (4), supplied 10-32 x 1/2" Pan-Head
Phillips screws (item #1) and nylon spacers (item #7).
4. Secure the AutoScope Ceiling Mount Adapters/Projector Stands to the motor using
the two (2), supplied 10-32 x 1/4" Flat-Head Phillips screws (item #3).
Figure 3-7. AutoScope Lens Motor Installation
After you have installed the AutoScope lens motor, proceed with Mounting the RS-900
on page 28.
24
Runco RS-900 Owner's Operating Manual