Runco RS-900 Owner's Operating Manual page 41

1. Place the projector upside down on a blanket or other soft surface.
2. Install a nylon spacer (item #3) at each mounting hole location.
3. Line up the four mounting holes on the CineWide base plate (item #2) with those on
the bottom of the projector.
4. If you are mounting the RS-900/CineWide on a ceiling: Line up the four holes on
the projector ceiling mounting plate (included with the projector ceiling mount kit) with
those on the bottom of the projector.
The hole pattern on the CineWide base plate is identical to that on
Note
the ceiling mounting plate.
5. Secure the CineWide base plate (and ceiling mounting plate, if needed) to the
projector with the M6x12mm screws (item #1) and nylon spacers provided with the
CineWide lens base plate.
1. Do not use the mounting screws provided with the ceiling
Caution
mounting plate. Use only the hardware provided with the
CineWide lens base plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
Runco RS-900 Owner's Operating Manual 27
Installation