Replacing The Lamp - InFocus in5122 Quick Start Manual

Replacing the lamp

Lamps have a finite product life. Using the lamp for long periods of time can cause
the pictures to become dim and the color tone to become poor. Each lamp has a
different lifetime, and some may burst or burn out soon after you start using them.
Purchasing a replacement lamp ahead of time is recommended. To purchase
a new lamp, contact with your dealer and ask for the following the lamp part
number.
Part number : SP-LAMP-064
1.
Turn the projector off, and unplug the power cord.
Allow the projector to cool for at least 45 minutes.
2.
Purchase a new lamp. If the projector is mounted
on a ceiling, or if the lamp has broken, you can
ask the dealer to replace the lamp.
If you replace the lamp yourself, follow these
procedures:
3.
Loosen the screw (marked by an arrow) on the
lamp door and then slide and lift the lamp door to
the side to remove it.
4.
Loosen the 3 screws (marked by arrows) on the
lamp, and slowly remove the lamp using the
handles. Never loosen any other screws.
5.
Insert the new lamp, and retighten the 3 screws on
the lamp firmly (which were previously loosened)
to lock it in place.
6.
Slide the lamp door back in place. Then firmly
fasten the screw on the lamp door.
7.
Turn the projector on and reset the lamp time
using the RESET LAMP HOURS item in the
SERVICE menu.
(1) Press the MENU button to display a menu.
(2) Point at the ADVANCED MENU in the menu using the
V / Λ button, then press the > button.
(3) Point at the OPTION in the left column of the menu
using the V / Λ button, then press the > button.
(4) Point at the SERVICE in the menu using the V / Λ button,
then press the > button.
(5) Point at the RESET LAMP HOURS using the V / Λ button,
then press the > button. A dialog will appear.
(6) Press the button to select "YES" on the dialog. This resets the lamp time.
>
CAUTION ►Do not touch anywhere inside of area where the lamp was
removed from the projector.
12
3
Lamp door
4
Handles
6