Playback Controls; Adjusting The Volume - Canon EOS C300 Instruction Manual

Playback Controls

When you play back a clip, operate the buttons on camcorder's body or on
the monitor unit or use the joystick and joystick guide to use fast playback,
play back frame-by-frame or skip clips. Refer to the following table.
Available Playback Types
Playback type
Buttons: Press the Ø or × button.
Joystick: During playback, push the joystick up or down.
Fast playback
Repeat to increase the playback speed to approximately 5x
15x
Frame advance/reverse Joystick: During playback pause, push the joystick up or down.
Buttons: Press the Ù button.
Skip to the beginning of
the next clip Joystick: Push the joystick right.
Buttons: Press the Ú button.
Skip to the beginning of
the current clip Joystick: Push the joystick left.
Buttons: Press the Ú button twice.
Skip to the previous clip
Joystick: Push the joystick left twice.
Buttons: Press the Ò button.
Return to playback mode
Joystick: Press the joystick itself (SET button).
NOTES
• There is no audio during any of the playback types listed in the previous table.
• During some special playback modes, you may notice some anomalies (blocky video artifacts, banding, etc.)
in the playback picture.
• The speed indicated on the screen is approximate.
• During frame advance, the time advanced between frames depends on the video configuration used:
0.2 seconds (for 1280x720/24.00P, 1280x720/23.98P or 1280x720/59.94P), 0.25 seconds (for 1280x720/
50.00P) and 0.5 seconds for other video configurations.
• You can press the DISP. button to turn the joystick guide display on and off.

Adjusting the Volume

During playback, audio will be available through the × (headphone)
terminal; the audio signal will also be output through the HD/SD SDI
terminal and the HDMI OUT terminal.
Adjusting the Headphone Volume
Press the HEADPHONE +/- buttons to adjust the volume.
NOTES
• For details on changing the audio channel, refer to
Channel
(A 95).
• You can also adjust the headphone volume with the [¡ Audio Setup]
> [Audio Output] > [Headphone Volume] setting.
Operation
60x the normal speed.
Selecting the Audio
Playback
129
× (headphone)
terminal
HEADPHONE +/- buttons