Playback Controls - Canon EOS C100 Mark II Instruction Manual

Playback Controls

When you play back a clip, operate the buttons on the camcorder's body or
use the joystick and joystick guide to use fast playback, play back frame-
by-frame or skip clips. Refer to the following table.
Available playback types
Playback type
Buttons: Press the Ø or × button.
Joystick: During playback, push the joystick up or down.
Fast playback
Repeat to increase the playback speed to approximately 5x
15x
Frame advance/reverse Joystick: During playback pause, push the joystick up or down.
Buttons: Press the Ù button.
Skip to the beginning of
the next clip Joystick: Push the joystick right.
Buttons: Press the Ú button.
Skip to the beginning of
the current clip Joystick: Push the joystick left.
Buttons: Press the Ú button twice.
Skip to the previous clip
Joystick: Push the joystick left twice.
Buttons: Press the Ò button.
Return to playback mode
Joystick: Press the joystick itself.
NOTES
• There is no audio during any of the playback types listed in the previous table.
• During some playback modes, you may notice some anomalies (blocky video artifacts, banding, etc.) in the
playback picture.
• The speed indicated on the screen is approximate.
• During frame reverse, the interval between frames is 0.5 seconds, which is longer than the interval during
frame advance.
• You can press the DISP. button to turn the joystick guide display on and off.
Adjusting the Volume
During playback, audio will come from the monaural built-in speaker or
headphones. When you connect headphones to the × (headphone)
terminal, the built-in speaker will be muted.
1 Open the [Headphone Volume] or [Speaker Volume] submenu.
[¡ Audio Setup] > [Audio Output] > [Headphone Volume] or
[Speaker Volume]
2 Select the desired level and then press the joystick.
• Select [Off] to mute the audio.
Operation
60x the normal speed.
Playback
[¡ Audio Setup]
[Audio Output]
[Headphone Volume]
[Speaker Volume]
[8]
129