Canon EOS C300 Instruction Manual page 52

Recording Video
2 Press the START/STOP button to begin recording.
• Recording starts. The tally lamp illuminates and the recording
indicator [ÜREC] appears at the top of the screen.
52
• You can use the START/STOP button on the back of the
camcorder, the front of the camcorder (next to the lens
mount), the grip unit or the monitor unit.
3 Press the START/STOP button to pause the recording.
• The clip* is recorded to the CF card and the camcorder enters
record pause mode. The tally lamp will also go out.
* "Clip" refers to one movie unit from the point you press the START/STOP
button to start recording until you press again to pause the recording. You can
also include custom picture settings (A 114) and metadata (A 96) with the
clip.
IMPORTANT
• Observe the following precautions while the CF2 or CF3 access indicator is illuminated in red. Failure to do
so may result in permanent data loss.
- Do not open the CF card slot cover of the CF card slot being accessed and remove the CF card.
- Do not disconnect the power source or turn off the camcorder.
• Be sure to save your recordings regularly (A 143), especially after making important recordings. Canon shall
not be liable for any loss or corruption of data.
NOTES
• You can use [w Other Functions] > [Rec Review] (A 105) to review part or all of the last clip recorded.
• If you set an assignable button to [Add $ Mark] or [Add % Mark] (A 111), you can press the button to add
an $ mark or % mark to the last clip recorded.
• You can use [w Other Functions] > [Clips] > [Delete Last Clip] (A 166) to delete the last clip recorded.
However, you cannot delete the last clip if double slot recording is on.
• When you set the [w Other Functions] > [SDI Rec Command] setting to [On] and you connect the
camcorder to another device using the HD/SD SDI terminal, if you start or stop recording with the camcorder,
the other device will also start or stop recording.