Assembly Instructions - Kenmore 122.16124900 Use And Care Manual

ASSEMBLY INSTRUCTIONS

1. Locate the gas regulator (1-1). Grasp the regulator (1-1)
with the knob (1-2) facing directly up. Line up the collar on
the regulator (1-1) with the open end of the burner tube (1-
3) as shown in fig. 1.
2. Screw the regulator (2-1) into the open end of burner (2-2)
as shown in fig. 2.
3. Once the regulator is in as far as it will go, tighten regulator
nut with the supplied wrench. Turn the regulator so that the
knob is facing forward. Note: Always make sure the
regulator is secured facing forward in the fully locked in
position before attaching propane cylinder.
4. Be sure the gas control knob (3-1) is in the "OFF" position.
Check to make sure threaded areas on cylinder and
regulator are clean. Screw the propane cylinder (3-2) onto
the regulator (3-3) making sure to engage threads correctly
to achieve proper connection. To remove the propane
cylinder (3-2) unthread the cylinder from the regulator (3-3)
as shown in fig.3.
Fig.1
Fig.2
Fig.3
7
(1-3)
(1-1)
(1-2)
(2-1)
(2-2)
(3-2)
(3-3)
(3-1)