Pre-Assembly Instructions - Kenmore 650-30643-0 Owner's Manual

NOTE: The normal flow of gas through the
regulator and hose assembly can create a
humming noise. A low volume of noise is
perfectly normal and will not interfere with
operation of the grill. If humming noise is loud
and excessive you may need to purge air from
the gas line or reset the regulator excess gas
flow device. This purging procedure should be
done every time a new LP gas tank is
connected to your grill. For help with this
procedure refer to page 13, step 4, or call the
Customer Service Helpline 8 AM to 5 PM EST
at: 1-800-469-4663
CAUTION: Beware of Flash-back
CAUTION: Spiders and small insects
occasionally spin webs or make nests in the grill
burner tubes during transit and warehousing.
These webs can lead to gas flow obstruction
which could result in a fire in and around burner
tubes. This type of fire is known as "FLASH-
BACK" and can cause serious damage to your
grill and create an unsafe operating condition for
the user.
Although an obstructed burner tube is not the
only cause of "FLASH-BACK", it is the most
common cause.
To reduce the chance of "FLASH-BACK", you
must clean the burner tubes before assembling
your grill, and at least once a month in late
summer or early fall when spiders are most
active. Also perform this burner tube cleaning
procedure if your grill has not been used for an
extended period of time.
Visually check the burner flames prior to each
use,The flames should look like this picture,if they do
not ,refer to the burner main tenance part of this manual
P3