Setting Up The Imager; Install The Interface Cable - Datalogic QuickScan i Product Reference Manual

Getting Started

Setting Up the Imager

Follow the steps provided in this section to connect and get your imager up and commu-
nicating with its host:
1.
2.
3.
4.

Install the Interface Cable

The imager kit you ordered to match your interface should provide a compatible cable
for your installation. If not, contact
Seat the cable assembly into the imager, aligning both the connector, aligning the cable
clip with its opening as shown in the insert portion of
RS-232 Serial Connection —
ager to the terminal/PC serial port via the RS-232 cable as shown in
minal will not support POT (Power Off the Terminal) to supply imager power, use the
approved power supply (AC Adapter). Plug the AC Adapter barrel connector into the
socket on the RS-232 cable connector and the AC Adapter plug into a standard power
outlet.
Figure 1. Connecting the Interface Cable/RS-232 Connection
Connecting at
the Imager
To Host
Disconnecting at
the Imager
Other connection types are described below and illustrated in
6
Install the Interface Cable
Select the Interface Type
Configure Interface Settings
Configure Other Features
Cable
Cable Strain Relief
Cable Clip (Latch)
Insert a paperclip
into this hole to
release the
cable latch
Strain Relief
Cable
(only if not using factory settings for that interface)
(if modifications are needed from factory settings)
Technical Support
Figure 1
Turn off power to the terminal/PC and connect the im-
Bottom of Imager
Interface Cable Port
.
.
. If the ter-
Figure 1
.
Figure 2
QuickScan® QD2100