Msi Set Length 2 - Datalogic QuickScan i Product Reference Manual

MSI — cont.

MSI Set Length 2

This feature specifies one of the barcode lengths for
maximum label length if in
Length
The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore this length). Pad
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT MSI LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in the Keypad Appendix that represent
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See the table below for some examples of how to set this
feature.
Table 38. MSI Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT MSI LENGTH 2 SETTING
Scan Two Characters From the
4
Keypad Appendix
5 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Variable Length
Mode. Length includes the barcode's check, data, and full-ASCII shift characters.
the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake, before the last character scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
00 (Ignore This
Length)
'0' and '0'
MSI Length Control
Mode, or the second fixed length if in
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
MSI
. Length 2 is the
Fixed
50 Characters
'5' AND '0'
291