Permanent Settings In Programming Mode; Products; Setting The Water Hardness - Jura ENA Micro 9 One Touch Instructions For Use Manual

4 Permanent settings in programming mode

4 Permanent settings in
programming mode

Products

J
WARNING
Hot coffee, hot steam and hot water can cause
scalding. Scalding is a serious burn.
T Use extreme care when handling hot liquid
or steam.
T Allow liquid to cool down before drinking.
T In the event of scalding, rinse affected area
with cold water and seek medical attention.
T Keep children AWAY.
You can make the following permanent settings for
espresso and coffee:
U
Amount of water:
0.5 OZ
(25 ml – 240ml) (per cup)
U
Coffee strength:
NORMAL
U
Temperature:
NORMAL
You can make the following permanent settings for
latte macchiato and cappuccino:
U
Amount of milk foam:
U
Interval: –
0 SEC 60 SEC
U
Coffee strength:
NORMAL
U
Amount of water:
0.5 OZ
(25 ml – 240ml)
U
Temperature:
NORMAL
You can make the following permanent setting for
hot water:
U
Amount of water:
0.5 OZ
(25 ml – 450 ml)
Permanent settings in programming mode always
follow the same model.
Example: Permanently change the coffee strength
( ) for espresso from
FLAVOUR
.
NORMAL
Precondition: is displayed.
READY
k T Press and hold the Rotary Switch until
appears.
RINSE
18
–
8.0 OZ
,
STRONG
,
HIGH
–
3 SEC 120 SEC
,
STRONG
–
8.0 OZ
,
HIGH
–
15.0 OZ
to
STRONG
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to enter the
program item.
SELECT BUTTON
E Next select the button of the product for
which you would like to make settings.
No product is prepared at this point.
< T Press the Espresso button.
ESPRESSO
WATER
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to enter the
program item.
STRONG
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to confirm the
setting.
, the coffee strength is set.
OK
FLAVOUR
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to exit the program
item.
PRODUCT
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY

Setting the water hardness

E If you are using the CLEARYL Blue filter
cartridge and have activated it in program-
ming mode, you will not be able to adjust
the water hardness.
The harder the water is, the more frequently the
ENA needs to be descaled. It is therefore important
to adjust the water hardness.
The water hardness can be adjusted on a continu-
ous scale between 1° dH and 30° dH.
is
PRODUCT
is
FLAVOUR
is
NORMAL
is
EXIT
is
EXIT