Front Bezel Security - HP Compaq 8100 Elite Hardware Reference Manual

Front Bezel Security

The front bezel can be locked in place by installing a security screw provided by HP. To install the
security screw:
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. If the computer is on a stand, remove the computer from the stand.
6. Remove the access panel and front bezel.
7. Remove one of the five silver 6-32 standard screws located on the front of the chassis behind the
bezel.
NOTE:
Figure 55
8. Replace the front bezel.
ENWW
Regardless of the power-on state, voltage is always present on the system board as
Your computer may look different than the illustration shown below.
Retrieving the Front Bezel Security Screw
Installing a Security Lock 47