HP Compaq 8100 Elite Hardware Reference Manual page 20

9. Open both latches of the memory module socket (1), and insert the memory module into the socket
(2).
NOTE:
Figure 10
NOTE:
the tab on the memory socket.
A DIMM must occupy the black DIMM0 socket.
NOTE:
DIMM4.
10. Push the module down into the socket, ensuring that the module is fully inserted and properly
seated. Make sure the latches are in the closed position (3).
11. Repeat steps 9 and 10 to install any additional modules.
12. Replace the access panel.
13. If the computer was on a stand, replace the stand.
14. Reconnect the power cord and turn on the computer.
15. Lock any security devices that were disengaged when the access panel was removed.
The computer should automatically recognize the additional memory the next time you turn on the
computer.
14 Hardware Upgrades
Your computer may look different than the illustration shown below.
Installing a DIMM
A memory module can be installed in only one way. Match the notch on the module with
Populate the DIMM sockets in the following load order: DIMM1, DIMM3, DIMM2, then
ENWW