Download  Print this page

HP Compaq 8100 Elite Hardware Reference Manual Page 32

Small form factor business pc/workstation.
Hide thumbs

Advertisement

8.
Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided
four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric
guide screws are black. Refer to
the extra M3 metric guide screws location.
CAUTION:
components of the drive.
NOTE:
the new one.
NOTE:
Figure 23
9.
Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
NOTE:
Figure 24
26
Hardware Upgrades
Use only 5-mm long screws as guide screws. Longer screws can damage the internal
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
Your computer may look different than the illustration shown below.
Installing Guide Screws in the Optical Drive
Your computer may look different than the illustration shown below.
Installing the Optical Drive
Installing and Removing Drives on page 21
for an illustration of
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Compaq 8100 Elite

This manual is also suitable for:

Z200

Comments to this Manuals

Symbols: 0
Latest comments: