HP Compaq 8100 Elite Hardware Reference Manual page 45

7. Replace the four screws in the bottom of the carrier to hold the drive securely in place.
NOTE:
Figure 43
8. Place the thermal sensor on top of the hard drive in a position that does not cover the label (1) and
attach the thermal sensor to the top of the hard drive with the adhesive strip (2).
NOTE:
Figure 44
ENWW
Your computer may look different than the illustration shown below.
Replacing the Security Screws
Your computer may look different than the illustration shown below.
Replacing the Thermal Sensor
Installing and Removing Drives 39