HP Compaq 8100 Elite Hardware Reference Manual page 25

12. To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis (1) so that the bracket on the card is
aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion
socket on the system board (2).
NOTE:
Figure 15
NOTE:
seats properly in the expansion card slot.
13. Rotate the slot cover retention latch back in place to secure the expansion card.
NOTE:
Figure 16
14. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
ENWW
Your computer may look different than the illustration shown below.
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole connector
Your computer may look different than the illustration shown below.
Closing the Expansion Slot Retainer
Removing or Installing an Expansion Card 19