After Completing The Job; Leveling And Door Closing; Door Alignment - Kenmore 795.6900 Series Service Manual

3-9 AFTER COMPLETING THE JOB

Make sure that the four corners of the door gasket are
not folded over. To ensure a good seal, apply a small
amount of silicon grease on the gasket.
Corner

3-10 LEVELING AND DOOR CLOSING

2. Remove the base grille. The two Leveling Screws are
located on the bottom of the refrigerator on either side.
3. Insert a flat screwdriver in slots to adjust the Leveling
Screws. Turn the leveling screw clockwise to raise
the side of the refrigerator or counterclockwise to
lower it. It may take several turns of the Leveling
Screw to adjust the tilt of the refrigerator.
Corner
5. Replace the base grille.
Place level tool on refrigerator shelf as shown below
to check if unit is level.

3-11 DOOR ALIGNMENT

- 24 -
.