After Completing The Job; Leveling And Door Closing; Door Alignment - Kenmore 795.7620 Service Manual

3-9 AFTER COMPLETING THE JOB

Make sure that the four corners of the door gasket are
. To en
not folded over sure a good seal, apply a small
amount of silicon grease on the gasket.
Corner

3-10 LEVELING AND DOOR CLOSING

To avoid vibration, the unit must be leveled. If necessary adjust
the Leveling Legs to compensate for unevenness of the floor.
The front should be slightly higher than the rear to aid in door
closing.
Your refrigerator has two Front Leveling Screws - one on the
right and one on the left. If your refrigerator seems unsteady or
you want the doors to close more easily, adjust the
refrigerator's tilt using the instruction below:
1. Plug refrigerator power cord into a 3-prong grounded outlet.
Move the refrigerator into its final position.
2. Remove the base grille. The two Leveling screws are
located on the bottom of the refrigerator on either side.
3. Insert a flat screwdriver in slots to adjust the Leveling
Screws. Turn the leveling screw clockwise to raise the side of
the refrigerator or counterclockwise to lower it. It may take
several turns of the Leveling screw to adjust the tilt of the
refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some of the weight off the Leveling Screws.
This makes it easier to adjust the screws.
4. Open both doors again and check to make sure that they
close easily. If not, tilt the refrigerator slightly more to the rear
by turning both Leveling Screws clockwise. It may take several
more turns, and you should turn both Leveling Screws the
same amount.
Corner
5. Replace the base grille.
Place level tool on refrigerator shelf as shown below to check if
until is level.

3-11 DOOR ALIGNMENT

If the space between your doors is uneven, follow the
instructions below to align the doors:
1. Gently pry off the Top Hinge Cover with a flat head
screwdriver and remove. Loosen the Top Hinge Bolts using a
10mm or 13/32 in socket wrench or open-end wrench.
2. Have someone hold the freezer door so the space between
the two doors is even, and retighten the top hinge bolts.
3. Replace the top hinge Cover.
- 24 -
.