Kenmore 795.6900 Series Service Manual page 13

Remove Washer and set aside.
Using a 1/4 socket wrench, loosen and remove
Hinge Pin from the Middle Hinge Bracket.
Fig. 21
Middle Hinge
Bracket
Bolts
Middle
Hinge Pin
Fig. 36
Use a 10mm or 13/32 inch socket wrench to remove
the 2 bolts in Middle Hinge Bracket. Remove 2
screws. Set Middle Hinge Bracket and other parts
aside.
With a flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side
of refrigerator housing.
Fig. 37
Remove the 2 outer screws from cabinet frame as
shown.
You will need these holes for the Middle Hinge Bracket.
Fig. 38
Place screws into outer holes on right side of cabinet.
Attach cover on the right side. Cover is force-fitted.
Fig. 39
Screws
(2)
Washer
- 13 -
Flip the middle hinge bracket and position on
left side of refrigerator and re-attach with
two bolts and a 2 phillips screws.
Fig. 40
Attach Middle Hinge Pin and r
Put refrigerator door down over the Hinge
Pin on the Middle Hinge Pin Bracket.
Fig. 41
Washer
Middle
Hinge Pin
Line up Top Hinge with holes in top of
refrigerator. Use the 3 bolts to replace the Hinge.
Fig. 42
Top Hinge Pin
Tighten Bolts. Force-fit T op Hinge Cover over top
Hinge.
Fig. 43
eplace washer .
8 1 g . F i