Disassembly; Fan And Fan Motor; Defrost Control Assembly; Lamp - Kenmore 795.6900 Series Service Manual

Hide thumbs Also See for 795.6900 Series:
Table of Contents

Advertisement

3. DISASSEMBLY

3-1 FAN AND FAN MOTOR

1. Remove the freezer shelf. (If your refrigerator has an
icemaker, remove the icemaker first).
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille by removing one screw and pulling the
grille forward.
4. Remove the Fan Motor assembly by loosening 2 screw and
disassemble the shroud.
5. Pull out the fan and separate the Fan Motor and Bracket.
BRACKET
MOTOR
GRILLE

3-2 DEFROST CONTROL ASSEMBLY

Defrost Control assembly consist of Drefrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature.
Fuse-M is safety device for preventing over-heating of the
Heater when defrosting.
At 72°C, it turns the Defrost Heater off.
1. Pull out the grille assembly. (Figure 2)
2. Separate the connector with the Defrost Control assembly
and replace the Defrost Control assembly after cutting the Tie
Wrap. (Figure 3)
GRILLE ASSEMBLY
Fig. 2
FAN MOTOR
FAN
Fig. 1
DEFROST-CONTROL
ASSEMBLY
Fig. 3

3-3 LAMP

3-3-1 REFRIGERATOR COMPARTMENT LAMP
1. Unplug the power cord from the outlet.
2. Remove Refrigerator shelves.
3. Release the hooks on both ends of the lamp shield and pull
the shield downward to remove it.
4. Turn the lamp counterclockwise.
5. Assemble in reverse order of disassembly.
6. Replacement bulb must be the same specification as the
original (Max. 60 W-2EA).
3-3-2 FREEZER COMPARTMENT LAMP
1. Unplug refrigerator or disconnect power.
2. Reach behind light to remove bulb.
3. Replace bulb with a 60W appliance bulb.
4. Plug in refrigerator or reconnect power.
- 8 -
Fig. 4
Fig. 5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

795.7900 series795.7809 series

Table of Contents