Kenmore 795.6900 Series Service Manual page 20

Remove Washer and set aside.
Using a 1/4 socket wrench, loosen and remove
Hinge Pin from the Middle Hinge Bracket.
Fig. 21
Middle Hinge
Bracket
Bolts
Middle
Fig. 84
Hinge Pin
Carefully lift up the freezer door. Remove and place
it on a non scratching surface.
Turn freezer door upside down.
With door upside down, loosen the 2 screws and
remove the Door Closer/Stop.
Fig. 85
Door Closer/Stop
Loosen the 2 screws to remove the Bottom Hinge
Pin Insert Bracket with Hinge Pin Insert.
Fig. 86
Hinge Pin
Insert Bracket
Screws
(2)
Washer
Hinge Pin
Insert
- 20 -
Remove the screw on the opposite side of the door.
This screw is no longer necessary and can be
discarted.
Move the Hinge Pin Insert Bracket to the other side
of the door, keeping the same orientation, and push
the Hinge Pin Insert into the hole on the left side of
the bracket. Insert the 2 screws as shown below.
Fig. 87
Take Door Closer/Stop and flip. Line up screw
holes and mount on left side of door bottom with
the 2 screws. Turn door upright and set aside.
Door Closer/Stop
Use a 10mm or 13/32 inch socket wrench to remove
the 2 bolts in Middle Hinge Bracket. Remove 2
screws. Set Middle Hinge Bracket and other parts
aside.
Fig. 21
Middle Hinge
Bracket
Bolts
Fig. 89
Fig. 88
Screws Screws
(2) (2)