If you have a problem
This appliance was inspected thoroughly and was in good operating condi-
tion when it was shipped from the factory. If a minor problem occurs, it
usually can be solved quite easily when the cause is found. Therefore, this
check list is provided to assist you.
Problem
Possible cause
A. Cleaner 1. Not firmly plugged in.
2. No voltage in wall plug.
3. Blown fuse/tripped breaker.
4. Thermal protector tripped.
B. Cleaner 1. Bag full.
2. Bag not opening.
suction
low
3. Obstruction in hose, wands,
or nozzle connector.
4. Secondary filter dirty.
5. Suction regulator
lmproperlv set.
C. Nozzle
1. Low cleaner suction.
2. Obstruction in nozzle
won't
pick up
connector.
3. Nozzle brush worn.
Service
If the problem persists, check the Yellow Pages of your telephone book under
"Vacuum Cleaners-Household" for your nearest Hoover Factory Service
Center or Authorized Warranty Service Dealer where approved HOOVER
service and genuine HOOVER replacement parts may be obtained. Provided
with this product is a listing of the Hoover Factory Service Centers. If you are
unable to obtain the information you need from the Yellow Pages, contact a
Hoover Factory Service Center to find your nearest Authorized Warranty
Service Dealer for service under warranty, follow the instructions in the
warranty provided with this product.
Do not send your cleaner to The Hoover Company in North Canton for service
as this will only result in a delay.
Always identify your cleaner by the complete model number when requesting
information or ordering parts. (The model number appears on the bottom of
the cleaner.)
If further assistance is needed, contact The Hoover Comapny, Consumer
Affairs Department, North Canton, Ohio 44720,216-499-9200.
1 1
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset breaker.
4. See thermal protector
section. (pg. 9)
1. Change paper bag.
2. Open bag by pulling folds.
3. Remove foreign object.
5. Set suction regulator
properly.
1. See Item B
2. Remove foreign object.
3. Replace nozzle brush.