Fill in and retain The HOOVER vacuum cleaner you have just purchased is a combination cleaner. It has a nozzle for use on carpet and floors and cleaning tools for other tasks. The model and serial number are located on the bottom of the cleaner.
Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped Into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer.
Unpacking The cleaner assembled will look like the drawing below. Unpack cleaner from carton and identify the parts shown. Re- move and dispose of the card- board packing. A. Canister cleaner B. Rug and floor nozzle C. Paper bag D. Extension wands and hose...
How to assemble 1. Connect hose insert hose end with cord into opening of cleaner, lining up largest projection on hose with largest notch of opening. Turn hose to the right to tighten. To disconnect, depress latch, and turn hose to the left. 2.
A variety of useful cleaning tools is included with your cleaner. These tools and their uses are shown below. The wail/floor brush is available at a nominal cost from your Authorized Hoover Dealer, a Hoover Factory Service Center or by writing to The Hoover Company, North Canton, Ohio 44720.
To connect and remove tools Tools attach to wand or hand grip by rotating plastic latch ring until slots in the opening align; insert tool and turn latch ring, as shown, to lock tool in place. To remove tool, reverse the above procedure.
Page 9
Where to buy Bags may be purchased from your local Authorized Hoover Dealer or from a Hoover Factory Service Center. When purchasing bags, be sure to give the model number of your cleaner. What to buy Use HOOVER bag Type K with this cleaner.
Obstructions Remove larger items from carpet and floor surfaces before vacuuming to help prevent obstructions in hose, wands or nozzle connector, and to maintain cleaning effectiveness of your cleaner. There are two conditions that will indicate that an obstruction has occurred: 1.
Rug and floor node To maintain cleaning effectiveness of your rug and floor nozzle, the brushes may need to be replaced occasionally. See your nearest Hoover factory Service Center or Authorized Warranty Service Dealer for new brushes. Lubrication The motor is equipped with two bearings that contain sufficient lubrication for the life of the motor.
Center or Authorized Warranty Service Dealer where approved HOOVER service and genuine HOOVER replacement parts may be obtained. Provided with this product is a listing of the Hoover Factory Service Centers. If you are unable to obtain the information you need from the Yellow Pages, contact a...
Page 13
0 @j HOOVER and are trademarks of THE HOOVER COMPANY, NORTH CANTON, OHIO 44720 LithoUSA 56513-310 1 I-90 S3619/27...