Keypad Control Menu (K3); Selection Of Control Place - Honeywell NXL User Manual

7
62(96)

7.4.3 Keypad control menu (K3)

In the Keypad Controls Menu, you can choose the control place, edit the frequency reference and
change the direction of the motor. Enter the submenu level with the Menu button right.
7.4.3.1

Selection of control place

There are three different places (sources) which the frequency converter can be controlled from. For
each control place, a different symbol will appear on the alphanumeric display:
Change the control place by entering the edit mode with the Menu button right. The options can
then be browsed through with the Browser buttons. Select the desired control place with the Enter
button. See the diagram below. See also Chapter 7.4.3 above.
STOP
STOP
Figure 7-7. Selection of control place
Parameters in Menu
K3
P3.1 = Selection of control
place
R3.2 = Keypad reference
P3.3 = Keypad direction
P3.4 = Stop button activation
P3.5 = PID reference 1
P3.6 = PID reference 2
Control place
I/O terminals
Keypad (panel)
Fieldbus
READY
I/O term
READY
I/O term
Control Keypad
Selections
1 = I/O terminals
2 = Keypad
3 = Fieldbus
0 = Forward
1 = Reverse
0 = Limited function of Stop
button
1 = Stop button always
enabled
Symbol
I/O term
Keypad
Bus/Comm
READY
STOP I/O term
READY
STOP I/O term
READY
STOP I/O term
enter
Honeywell Honeywell
Honeywell Honeywell