Terminals Of Projector - Christie LX1500 User Manual

Terminals of Projector

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity
of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired
combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer
where you purchased a projector.
INPUT/OUTPUT
TERMINALS
Replacement of Terminal
Note:
✔
• I n the replacement of terminal board, the MAIN
ON/OFF switch should be OFF position.
1
Remove 2 Screws on a terminal.
2
Pull out the terminal by holding handle.
3
Replace the terminal. Insert a new terminal along
Guide to fit Plug into Socket.
4
Tighten screws to secure the terminal.
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board (Termi-
nal Board), contact your sales dealer. When contacting the
sales dealer, tell the Option Control Number (Op.cont.No.)
in the menu that is located on the bottom of the information
menu.(See page 28)
4 TERMINAL SLOTS (Factory set)
SERIAL PORT IN
DIGITAL (DVI-D)
SERIAL PORT OUT
G B R H/HV V
VIDEO/Y
Pb/Cb Pr/Cr
R/C JACK USB
RESET
Plug
DVI / D-sub 15 Terminal
ANALOG
S-VIDEO
5-BNC / VideoTerminal
▼
L
Guide
Figure shows D-sub 15 terminal.
Installation
Screws
Socket
19