Common Problems - Oki Microline 520 Service Handbook

%4.4.05 Common Problems

4.4.05 Common Problems
1. Nothing happens when the unit is powered on.
The unit may not be plugged in. Check the power cord connection to the outlet and to the printer. If
a power strip is being used, make sure that it is powered ON. Check to be sure that an external
fuse hasnt blown or that a circuit breaker hasnt tripped.
2. The printer does not print when the computer sends data.
The printer may be deselected. If the SEL light is out, press the SEL button to select the printer.
The printer cable may not be securely connected. Check the cable to be sure that it is properly
connected to both the PC and the printer.
If you have installed the serial interface board, check to be sure that the board is firmly seated in the
printer.
3. A brand new ribbon has been installed and the printing is smeared and streaked.
The plastic shield on the ribbon is either loose or missing. The shield must be left on the ribbon
when you are installing the cartridge. To correct this situation, move the printhead to the center of
the platen (careful - the printhead may be HOT!) and lift off the ribbon cartridge. Check the ribbon
shield. If it is loose, secure it in place properly. If it is missing, locate it and install.
4. Static electricity causes the paper to stick.
In cold, dry weather, static charges can build up on continuous-form paper. This can make the
paper cling to the paper separator. If you have this problem during high-volume printing jobs, try
moving the single sheet paper guides on the separator together so that the paper rests on the
guides rather than on the separator itself.
5. The Print Quality and Character Pitch buttons on the front panel wont work.
The Operator Panel Function Item on the printer MENU can be used to disable these buttons. If the
printer is part of a customized system or if it is used by a number of people, the system manager
may have used this option to make sure the printer is always set properly.
NOTE:
This feature also prevents access to the Menu. To access the Menu, power OFF the printer, then
hold down the SEL key while powering ON.
6. Strange symbols and incorrect fonts appear on the output when a document is printed.
The printer driver that is engaged does not agree with the emulation selected for the printer.
To check the emulation selected, first make sure that paper is loaded. Then, press the SEL and
SHIFT buttons simultaneously to enter the Menu Mode. Next, press the GROUP button. This will
print the emulation selected.
If the emulation is not the one you want to use, press the SET button to change it to the one you
want before exiting the Menu Mode. To exit, press the SEL and SHIFT buttons.
If the emulation is correct, check your software documentation on how to select a printer driver.
Then, check to be sure that you have selected one of the drivers listed for that emulation. Refer
to the Printer Handbook for emulation/driver selections. The closer the driver is to the top of the
list in the Printer Handbook, the more compatible it will be with your printer. If your software does
not have any of the indicated drivers available, check with the software manufacturer to see if
they have added any additional drivers since you purchased your software.
If you have embedded any printer commands in your software, check to be sure that you have
entered them correctly.
7. Printing on the right side of the page is lighter or darker than the rest of the print on the page.
Although the printer automatically sets the head gap, it sometimes may need a minor adjustment.
To make this adjustment, enter the Menu Mode. Press SEL and SHIFT buttons simultaneously.
To change the setting for the Printhead Gap Adjust under the Setup Group, use the following
procedure.
Press GROUP until Setup Group prints.
Press ITEM until Printhead Gap prints.
Press SEL to change the setting. The default setting is 0. If the printing is sometimes lighter,
change the setting to - 1. If it is sometimes darker, change it to + 1.
Press SEL and SHIFT buttons simultaneously to exit Menu Mode.
ML520/521 ( 96-02-04 )