Samsung SCD-3083 User Manual page 24

Setup
WDR ON
M
Because there can be a difference in the effectiveness of HLC according to the amount of light
area in the screen, optimize the installation angle for the best HLC performance.
In a dark environment, the HLC is only activated when a high light that is larger than a certain area
is present.
The HLC is not activated in day light or when bright light is not present at night. (In NIGHT ONLY
mode).
Since the performance of the WDR function may be affected by the area of the bright part of the
screen, optimize the installation angle for the best WDR performance.
If you increase LIMIT, the screen display may be distorted.
If you use the VPS (Virtual Progressive Scan) function, the CCD reads differently so you can not use
WDR simultaneously. If you set VPS to ON, WDR will be automatically set to FIXED Mode.
This function reduces the background noise in a low luminance environment.
1. When the SETUP menu screen is displayed, select 'SSNR3' by using the Function
Setup switch so that the arrow indicates 'SSNR3'.
Select a desired mode using the Function Setup
2.
switch.
 Off : Deactivates SSNR3. Noise is not reduced.
 ON : Activates SSNR3 so that noise is reduced.
3. Set the SSNR3 mode to 'ON' and press the Function Setup switch.
4. Then you can adjust the noise reduction level.
You cannot set the SSNR3 to 'ON' or 'OFF' when the AGC mode of the EXPOSURE

menu is 'OFF'.
When adjusting the noise reduction level of the SSNR3 mode, remember that the higher

the level set, the more the noise level will be reduced but that after image may also occur.
24_ Setup
WDR OFF
SSNR3
▶ LEVEL
IIIIIIIIIIIIIIIIIIIII
Press SET to Return
15