Sony HDR-XR1 00 Operating Manual page 148

~ OFF
ON
GTips
• Positioning the subject at the cross point of the guide frame makes a balanced composition.
You can select the flash setting when you record photos using the built-in flash, or an external
flash (sold separately) that is compatible with your camcorder.
steps
ft
(HOME).:4Ii1"\SEnINGS).4 [Pi:fOTO SE:TTINGS]-
setting- 1-+
[QE]:....I
i='
~ AUTO
ON
(i)
OFF
(\I))
(!)
Notes
• The recommended distance to the subject when using the built-in flash is about 0.3 to 2.5 m
• Remove any dust from the surface of the flash before using it. Flash effect may be impaired if heat
discoloration or dust obscures the lamp.
• You cannot set this item when a filter or a conversion lens is attached to your camcorder.
• The i/CHG (charge) lamp (p, 8) flickers while charging the flash, and remains lit when the battery charge
is complete.
• If you use the flash in bright places such as when shooting a backlit subject, the flash may not be effective.
You can set this function when you record photos using the bUilt-in flash, or an external flash
(sold separately) that is compatible with your camcorder.
Steps
ft
-iifI
(HOME) (SETTINGS) - [PHOTO·SETTINGS] -[FLASH LEVEL] -
setting - [gEl-
@] -
(i+)
HIGH
~
NORMAL (i)
LOW (i-)
Does not display the guide frame.
Displays the guide frame.
[R] .
Automatically flashes when there is insufficient ambient light.
Always uses the flash regardless of the ambient brightness.
Records without flash.
[K]
Makes the flash level higher.
Makes the flash level lower.
82
~a'desired
[FI1:ASH
MODEl
a desired
"
,... A
to 8 feet).
(l