Sony HDR-XR1 00 Operating Manual page 144

~'ttASH (HDR~XR200/XR200V)
MODE
You can select the flash setting when you record photos using the built-in flash, or an external
flash (sold separately) that is compatible with your camcorder.
Steps
A
(HOME}-;:; (SETTINGS}:.....[MOVIESETTIf'.JGSi-
!
-IX
setting -
[QRl-I
+=>
~ AUTO
ON (S:)
OFF
((t))
(!)
Notes
• The recommended distance to the subject when using the built-in flash is about 0.3 to 2.5 m (1 to 8 feet).
• Remove any dust from the surface of the flash before using it. Flash effect may be impaired if heat
discoloration or dust obscures the lamp.
• You cannot set this item when a filter or a conversion lens is attached to your camcorder.
• The S:/CHG (charge) lamp (p. 8) flickers while charging the flash, and remains lit when the battery charge
is complete.
• If you use the flash in bright places such as when shooting a backlit subject, the flash may not be effective.
You can set this function when you record photos using the built-in flash, or an external flash
(sold separately) that is compatible with your camcorder.
Steps
A
(HOME) -;:; (SE,1TINGS) - [MOVIE SETTINGSl,- [FLASH LEVEL]
1,-00
setting
[QR]-I
+=>
-+
HIGH (S:+)
~
NORMAL (S:)
LOW (S:-)
You can set this function when you record photos using the built-in flash, or an external flash
(sold separately) that is compatible with your camcorder.
When you set [REDEYE REDUC] to [ON], then set [FLASH MODE] to [AUTO] or [ON],
appears. You can prevent redeye by activating the pre-flash before the flash flashes.
Steps
A
(HOME)- ;:; (SETTINGS) .:..... [MOVIE SETTINGS]
setting:- [QEl-1 1- 00
+=>
I'
Automatically flashes when there is insufficient ambient light.
Always uses the flash regardless of the ambient brightness.
Records without flash.
Makes the flash level higher.
Makes the flash level lower.
78
' " - "
[FLASH MODE]'L.
.
[REDEYE REDUCl-
'-+
- "'
a desired
-a
desired-
@
a
desired