Nokia E5–00 User Manual page 74

74 Connectivity
created, or Automatically
the device to connect to the destination
using this access point automatically.
Select Options
>
and from the following:
Network type — Select the internet
protocol type to transfer data to and
from your device. The other settings
depend on the selected network type.
Phone IP address (for IPv4
only) — Enter the IP address of your
device.
DNS addresses — Enter the IP
addresses of the primary and secondary
DNS servers, if required by your service
provider. To obtain these addresses,
contact your internet service provider.
Proxy server address — Enter the
address of the proxy server.
Proxy port number — Enter the port
number of the proxy server.
WLAN internet access points
Select Menu Ctrl. panel
>
and Connection
Access point, and follow the
instructions on the display. Or, open one
of the access point groups, select an
if you want
Advanced settings
Settings
>
Destinations
>
access point marked with
Edit.
Use the instructions provided by your
service provider to edit the following:
Connection name — Define a name for
the connection.
Data bearer — You might not be able
to edit the data bearer once defined.
Define a new access point if needed.
WLAN network name — Select
manually
you select an existing network,
network mode
mode are determined by the settings of
its access point device.
Network status — Define whether the
network name is displayed.
WLAN network mode — Select
hoc to create an ad hoc network, and to
allow devices to send and receive data
directly; a WLAN access point device is
not needed. In an ad hoc network, all
devices must use the same WLAN
network name.
>
WLAN security mode — Select the
encryption used: WEP, 802.1x, or
WPA2. (802.1x and WPA/WPA2 are not
available for ad hoc networks.) If you
© 2010 Nokia. All rights reserved.
or Search for networks. If
and WLAN security
, and select
Enter
WLAN
Ad-
WPA/