Nokia E5–00 User Manual page 168

168 Settings
Pre-shared key — If you select
WPA2 Pre-shared
>
shared private key that identifies your
device to the WLAN to which you
connect.
WPA2 only mode — To allow both TKIP
and AES (Advanced Encryption
Standard) encryption, select Off. To
allow AES only, select
Wireless LAN plugins
Select Menu Ctrl. panel
>
and Connection
an access point group.
The extensible authentication protocol
(EAP) plug-ins are used in wireless
networks to authenticate wireless
devices and authentication servers, and
the different EAP plug-ins make possible
the use of various EAP methods
(network service).
You can view the EAP plug-ins currently
installed in your device (network
service).
EAP plug-ins
1 To define the EAP plug-in settings,
select Options
WPA/
key, enter the
On
Settings
>
> Destinations, and
New access
>
point and define an access point
that uses WLAN as a data bearer.
2 Select 802.1x
security mode.
3 Select WLAN security settings
WPA/WPA2
settings.
Use EAP plug-ins
To use an EAP plug-in when you connect
to a WLAN using the access point, select
the desired plug-in and
Enable. The EAP plug-ins enabled for
use with this access point have a check
mark next to them. To not use a plug-in,
select Options > Disable.
To edit the EAP plug-in settings, select
Options > Edit.
To change the priority of the EAP plug-
in settings, select
priority to attempt to use the plug-in
before other plug-ins when connecting
to the network with the access point, or
Options Lower priority
>
plug-in for network authentication
after attempting to use other plug-ins.
© 2010 Nokia. All rights reserved.
or WPA/WPA2 as the
EAP EAP plug-in
> >
Options
>
Options Raise
>
to use this
>