Advertisement
3.
Linkage: Press the "linkage" button to read back all the status ID's
4.
Open/Close: Press either the "open" or "close" button to open or close the COM
port
5.
Mapping:
Select All Output: Click on "Select All Output" then
select the source on the main menu. This quickly
sets all the outputs to the same source.
Unselect All Output: This releases all the outputs
Select Input 1~8 Output: Select the input source,
then select the output port icon.
Example: click on "Select Input 1 – Output", then
select output port 1 & 2. The video and audio will
be sent to port 1 & 2.
6.
Fast Select:
Input Num – Output Num: This will set all input
Ports to its corresponding output port
ie. 1 to 2, 2 to 2
Input 1-8 – All Output: Quickly send the same
source to all outputs
7. Command Set
RS-232 Transmission format:
•
Baud rate:
•
Data length:
•
Parity check:
•
Stop bit:
•
Full details of the RS-232 protocols can be found on the CD provided:
D:\02 Documentation\01.Serial Command Set\8x8 Matrix_Command Set
Or
D:\02 Documentation\02.RS-232 Protocol Terminal\8x8 Matrix_ProtocolTerminal
9600 bps
8 bits
None
1 bit
Advertisement
