Figure 30 Controller Status Leds - Honeywell UMC800 Installation And User Manual

Operation
Status Indicators
Controller Status
The status of various controller parameters can be viewed through a number of displays.
1. The operator interface features a CONTROLLER STATUS display listing the status of various
parameters and is accessed from the UNIT SETUP display on the operator interface. See UMC800
Operator Interface User Guide for more details on the Controller Status display.
2. The User Utility program contains a Controller Diagnostic Summary window listing numerous
operating parameters and communication status. See UMC800 User Utility User's Guide and the on-
line help for more details on the Controller Diagnostic Summary window.
Alarm and status blocks
Additional controller status parameters can be monitored through the Analog System Status and Fast Logic
System Status blocks. These blocks are configured using the control builder. Outputs from these status
blocks can be wired to alarm groups and inputs to other function blocks. Controller parameters such as low
battery, hardware integrity, communications failure, and function block cycle times are monitored by these
status blocks. See document 51-52-25-64 UMC800 Function Block Reference Guide for more details on
these status blocks.
60
PROGRAM
Controller
Status
Indicators
CPU Module

Figure 30 Controller status LEDs

UMC800 Controller Installation and User Guide
OFFLINE
RUN
POWER
Lo BA T
FORCE
RUN
_
100 - 24 0 V ~
BA T
50 / 6 0 Hz
100 VA MAX.
Release F
4/01