Table 8 I/O Module Identification Record - Honeywell UMC800 Installation And User Manual

Mounting and Wiring
Plug-in Module Locations
Verify I/O module locations
The table below outlines the steps for identifying and recording the I/O module types in the controller.
Step
1
Verify that the module types installed in the controller card slots are correct according to the
controller model number. Refer to Table 6 to identify the module types.
2
Use to record the location, module type and signal type/range for each I/O module installed
in the controller.
NOTE
Table 7.
Controller
Slot No. (AI, AO, DI, DO, or PI/FI)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
* An Analog Input (AI) Module can be configured to accept multiple input types.
22
Module types should be installed in accordance with the limitations described in

Table 8 I/O module identification record

I/O Module Type
UMC800 Controller Installation and User Guide
Action
Signal Type/Range
(mV, V, mA, T/C, RTD, Ohms, pH)*
Al Ch 1 Al Ch 2 Al Ch 3
Terminal Block
Color
Al Ch 4
Release F
4/01