Starting A Firmware Update - Gigaset SL910 User Manual

Starting a firmware update

Prerequisite:
u
The phone is connected to the Internet (i.e., connected to a router,
u
The phone is in idle status, i.e.: no calls are being made, there is no internal con-
nection, no handset has opened a menu on the base.
Starting the firmware update manually
¤
In the Settings menu (
¤
Scroll to Firmware Update.
PIN and confirm with è.
If a new version of the base firmware is available, message New firmware available
- Update? is displayed.
¤
Press Yes to confirm.
Please note
u
The firmware update can take up to six minutes, depending on the quality of
your DSL connection.
u
During the update, the registered handsets temporarily lose their connec-
tion to the base.
Setting the automatic firmware update
¤
In the Settings menu (
¤
Scroll to Firmware Update.
next to Automatic Check.
If the function is activated, the base will check daily whether a new firmware ver-
sion is available. If this is the case, you will receive the message Start download?.
¤
Press Yes to confirm.
If you answer the prompt with No, you will no longer be informed about this
firmware update. The message will not be displayed again until the next firmware
version is available. You can perform the firmware update manually (
Please note
If the phone is not connected to the Internet at the time the check for new
firmware is carried out (e.g., no router connection), then the check will be car-
ried out as soon as the phone is reconnected to the Internet.
¢
page 24), touch [
Touch the corresponding '.
¤
¤
Touch Update Firmware.
¢
page 24), touch [
¤
Activate/deactivate the function with the button
Updating the base firmware
Ê
System].
¤
Enter the system
Ê
System].
¢
page 81).
¢
page 83).
83