Download Print this page

Firmware Update; Connections - Gigaset E290HX User Manual

Hide thumbs

Advertisement

Resetting the base using a key on the base
All handsets are de-registered. The system PIN is set back to the original code
0000.
¤
Unplug the power cable from the base
Paging key on the base
the base
Keep the key pressed for at least another 5 seconds

Firmware update

(depending on the base)
The handset supports firmware updating via the DECT radio link to the base/
router (SUOTA = Software Update Over The Air).
The base/router to which the handset is registered must also support
this function and be connected to the Internet
www.gigaset.com/compatibility
¤
Settings
current firmware version is displayed
firmware, updating is started
The update process may take up to 30 minutes. During this time,
only restricted handset use is available.
Automatically check whether there is new firmware:
¤
Settings
Automatic Check
If new firmware is available for the handset, a message to this effect is
displayed.
¤
Start the firmware update with OK.

Connections

(only on a CAT-iq router)
On the router, multiple connections can be set up and assigned to the hand-
sets. You can configure the following connection settings on the handset.
Change the name of a connection (line)
¤
Settings
available connections (lines) are displayed
OK
Connection Name
At the same time, reconnect the power cable to
OK
Handset
OK
Handset
OK (
= enabled)
OK
Base
Availability and operation of the functions
may differ on your telephone.
Keep pressed the Register/
OK
Update Firmware . . . the
Update
OK
Update Firmware
OK
Connections
Select connection
Change name of connection OK
Phone settings
OK . . . if there is new
OK . . . All
43

Advertisement

loading