Nav; Figure - Honeywell BENDIX/KING KLN 94 Pilot's Manual

KLN 94 Pilot's Guide
3.11.4.2 NAV 4 Page Format
The NAV 4 page has a unique for-
mat unlike any other KLN 94 page
(figure 3-117). The page bar is
removed on the NAV 4 page to uti-
lize the maximum screen height for
the map. The page being displayed,
NAV 4, is shown in the bottom right
corner of the screen.
Display segment one, on the far left side of the screen, now has five lines
rather than four lines on the other pages. It displays the following:
• Line 1 - Distance to the active waypoint
• Line 2 - Active waypoint identifier
• Line 3 - Desired track (DTK) in the LEG mode or OBS course in the
OBS mode. The DTK value flashes if the course selected on the
external CDI or HSI differs from the desired track by more than 10
degrees.
• Line 4 - Actual track (TK), bearing to active waypoint (BRG), radial
from active waypoint (RAD), or groundspeed
• Line 5 - Groundspeed, estimated time en route (ETE) to active way-
point, cross track error, or vertical navigation (VNAV) status
Lines 4 and 5 can be configured by the pilot to display any of the items
listed.
To configure lines 4 and 5 to display the desired Navigation items:
1. Press B to turn on the cursor.
2. Rotate the right outer knob coun-
terclockwise to position the
cursor over the desired line (fig-
ure 3-118)
3. Rotate the right inner knob to
select the desired item (figure 3-
119).
4. Press B to turn off the cursor
when done
Chapter 3 Basic GPS Operation

Figure 3-117

Figure 3-118
Figure 3-119
3-41